PDA

View Full Version : Mugen 360!!!!! Nos!



hrc85250r
09-15-2005, 01:10 AM
http://cgi.ebay.com/ebaymotors/NOS-MUGEN-360-KIT-HONDA-CR250-ELSINORE-CR-250-1978-79_W0QQitemZ4574575834QQcategoryZ34284QQssPageName ZWDVWQQrdZ1QQcmdZViewItem

it is for a cr, but im 99% sure they are the same for the atc's....holy $#!T that is sick!!!!!!!!!!!! look at the $$$$$$$$$$$$

MTS
09-15-2005, 10:03 AM
Actually...it dont fit the ATC unless you have your pipe modified cause the CR exaust port is off to the side while the ATC is dead center...but that is cool as heck anyways...wish i had an old CR now hahaha

hrc85250r
09-15-2005, 01:23 PM
sudco has the pipe for this kit in an atc in their clearance section...

Billy Golightly
09-15-2005, 01:43 PM
Thats pretty bad ass, all the parts and the literature there together.

grundlegrabber
09-16-2005, 07:29 AM
Never seen a NOS kit that complete! Holy christ, look at what that thing's going for !!!!! :crazy:

Howdy
09-16-2005, 08:15 AM
Never seen a NOS kit that complete! Holy christ, look at what that thing's going for !!!!! :crazy:

Don't you just wished you would have bought 10-15 of them and put them on the shelf. lol
Howdy

Troll 2
09-16-2005, 09:10 AM
It's interesting that the kit has new transmission gears. That cyl. sleeve is very thick at the bottom and those instructions show the cases ready for boring. Then two different size outlets on the exaust flanges. Looks like the kit will need head studs and a new special base gasket. Very cool.................... :beer

Lots_Of_Nothing
09-16-2005, 04:05 PM
It's interesting that the kit has new transmission gears. That cyl. sleeve is very thick at the bottom and those instructions show the cases ready for boring. Then two different size outlets on the exaust flanges. Looks like the kit will need head studs and a new special base gasket. Very cool.................... :beer

Uses stock studs/nuts, and a trimmed stock base gasket.