View Full Version : 250x frame mod
SWIGIN
01-25-2007, 08:15 PM
some pics of how to stretch a 250x frame 2 inches. im not done yet but this is how much got done in day one.
this is the 5th or 6th frame i stretched, with a plus 2 swingarm it ends up the same length as a 400ex...or slightly shorter then a trx 250r.
SWIGIN
01-25-2007, 08:21 PM
last pic for day 1
4cylinders
01-25-2007, 09:26 PM
hey, looks good, is that a spare frame? Would you happen to have a spare steering support? Keep posting, so we can check it out.
SWIGIN
01-25-2007, 09:29 PM
its my brothers frame. if your tall the 250x feels to short like a blaster so thats why we do this.
you need the steering stem clamp? if so id check on ebay
4cylinders
01-25-2007, 11:18 PM
hey, no the part on the bottom of the steering shaft, between the frame rails.
SWIGIN
01-25-2007, 11:22 PM
ok you want the stem bearing section...no i dont have that
how did you mess that up?
4cylinders
01-25-2007, 11:39 PM
hey, not messed up, need one for a project. Thanks for your time.
SWIGIN
01-26-2007, 07:09 PM
today i got it done except for the shock mount and fender brackets
i always tilt the tubes in front of the motor forward so if you put a 350x motor in the header will fit better. (i like to shorten the header instead of making it longer to go around the tubes)
jsimonh
01-26-2007, 07:33 PM
Looks good. Do they end up being as strong or stronger than stock?
SWIGIN
01-26-2007, 07:36 PM
well the first on we built was for my buddy and thats 9 years ago and its still going with no cracks or anything.
and he rides it real hard....heres some pics
Louis Mielke
02-02-2007, 06:33 PM
Hey, tells us a little bit about the guesseting you've done. i notice a few things you've added here and there and would like to know more. Anything else you gusset that might not be noticeable?
SWIGIN
02-02-2007, 06:47 PM
i use 16 gauge 1'' square tube
16 gauge 3/4 for some gussets
this frame is still using the stock motor and its not cracked at all so im not doing anything to the rear of the frame except for the foot peg area
when im putting a 350x motor in i cut the rear upper motor mount off(the left one) and weld threaded inserts in to the frame and use a bolt on mount
there are a few weak spots to look at on these frames, normally around the shock mount and around the tank
bad ex
02-12-2007, 05:11 PM
hey, how much do you want to stetch a 300ex frame?just wondering.thanks kevin
SWIGIN
02-12-2007, 05:26 PM
are you going to drop it off?
i dont want to ship something that big
just a strech with some gussets is $350
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.