View Full Version : 84r dragbike new 300cc kit

05-03-2007, 10:30 PM
Here is a pic of my 84 and some pics of it with the new carb and 300 motor:D

As a 250 it ran 5.611 in a 300ft dirt drag. Will find out soon what times it will run with the new motor.

05-03-2007, 10:52 PM
whats done to it besides the 300kit? what size carb? what kind of pipe?
OH and welcome to the boards!!!


05-03-2007, 11:08 PM
I did some minor porting and smoothing to the cylinder and polished the head and I
think the pipe and silencer are cobra it has a reed spacer an fl350 intake, power reeds and a 36mm pwk.

Billy Golightly
05-03-2007, 11:12 PM
very nice clean R! Welcome to the forums

05-03-2007, 11:16 PM
thanks for the welcome I have been meaning to join for a while now.

05-03-2007, 11:22 PM
very nice!

200x Basket
05-07-2007, 10:03 PM
times man, we need new times!!!

05-07-2007, 10:21 PM
The first race of the season were i race is may19 so i should find out my times with the new motor then. In the meantime i need to get the jetting dialed in, i will post new times as soon as i get them.

05-08-2007, 10:03 AM
Nice trike and welcome to the boards!!

05-08-2007, 10:09 AM
thats good times for no wheely bar and no stretch swinger .. NICE "R" !!

05-08-2007, 11:36 AM
Welcome to the site.Where are you racing?I would like to find a dragstrip for my big bore Tri-Z.Nice 300 honda Trike.

05-08-2007, 06:28 PM
That's the best air cooled 250 I've seen so far. Looks fantastic. Xtra points for using / racing it.

Oh, and :welcome: :welcome: :welcome: :welcome: :welcome: to the boards!!


05-08-2007, 08:37 PM
To start off i will answer moshman355's question i race at thunder valley motocross & dirt drags 10130 lynchburg Rd. East Rochester ohio phone.(330)-894-2341 come out and
race sometime i have only seen 1 other trike out there.
The bike can sometimes be a handfull on the starts , tires hook up really good. I will post some videos soon thanks for the compliments and thanks for the welcome everyone.

05-20-2007, 09:06 AM

Any port timing changes?

Have you had a chance to test and dial in yet?

05-20-2007, 10:48 AM

Any port timing changes?

Have you had a chance to test and dial in yet?

I took the cylinder before i installed it and i smoothed up the ports and sharpened up the transfer ports but did no port timing changes . I went to the drags yesterday and spent most of practice dialing in the bike, i got the jetting right then the flywheel key sheered after i got that figured out i made a few practice passes and it ran great
i was having a hard time keeping the front down . After all of that the rain started and i ended up not racing, the strip got real muddy:(

05-20-2007, 07:36 PM
that there is one clean 84. Nice to see another trike racin the 300ft tracks too.