lunchbox
01-26-2008, 10:05 PM
Hello,
I'm new around here and am trying to do some investigative work before I start spending money on a project. Now i've searched the forum (and the internet) but having found the specific measurements of a 200x front end.
So i'm hopin someone on here can help me out and take some measurements off their 200x for me... here's what I'm looking for:
#1) The outside diameter and length of the 200x neck (or stem).
#2) The size if the stem bolt as well as the offset of the stem bolt on the triple clamp in relation to the fork tubes.
#3) The overall length of the fork tube.
#4) The diameter of the fork tube.
#5) The degree of "rake" on the forks.
#6) The diameter of the front axle bolt/pin.
#7) The distance between the forks (inside to inside) where the front hub mounts.
I know these are a lot of question but if anyone could help me out I'd really appreciate it!!! Thanks in advance.
I'm new around here and am trying to do some investigative work before I start spending money on a project. Now i've searched the forum (and the internet) but having found the specific measurements of a 200x front end.
So i'm hopin someone on here can help me out and take some measurements off their 200x for me... here's what I'm looking for:
#1) The outside diameter and length of the 200x neck (or stem).
#2) The size if the stem bolt as well as the offset of the stem bolt on the triple clamp in relation to the fork tubes.
#3) The overall length of the fork tube.
#4) The diameter of the fork tube.
#5) The degree of "rake" on the forks.
#6) The diameter of the front axle bolt/pin.
#7) The distance between the forks (inside to inside) where the front hub mounts.
I know these are a lot of question but if anyone could help me out I'd really appreciate it!!! Thanks in advance.