Parts should be here the end of this week. So hopefully will have the ol girl going again by Monday or Tuesday :)
I'm glad you just decided to buy new clamps. Most cast fork clamps are difficult at best to clamp down and set up for boring.
And if you buy a TIG for aluminum, try to take a class or get lots of...
^X2 - Electrical (coil), too tight valve lash, low compression and too rich or lean jetting are all possibilities.
Learn something new everyday right??!!
Great job buddy!
So I tackled the job today. Drain the oil, I didn't thinking it would be ok but you need to drain it. The job was easy. Just had to tap on the side cover to break it free and wiggle it off the...