//ArrowChat Code
  • ATC200, ATC200M and ATC200S Technical Data


    Often exclaimed Honda's most popular and widest spread unit in their early ATV line, the ATC200 models are the bread and butter on the ATC heritage. Just about anyone who thinks of a three wheeler has the vision of the ATC200 come to his mind. As follows are the distinct specifications that separated the three main model designations of ATC200, ATC200S and ATC200M.

    Honda release several variants of the base ATC200 line excluding the "Big Red" line introduced around the same time. The ATC200 was the result of the natural evolution of the ATC185. A small bump in displacement coupled with the standard creature comfort upgrades provided a steady stream of updated models keeping the ATC line fresh and new without any large changes in the overall design.

    Most notable of these variations came in the form of the introduction of hydraulic telescoping forks on the usually suspension-less ATC models. Possibly following in Yamaha's footsteps, the front suspension helped greatly to ease the handling of the non-sport model ATCs. Also worth mentioning is the electric start capability of the ATC200M, possibly a careyover from the "Big Red" version of the ATC200 model.

    General ATC200 Specifications
    Production Years : 1981-1983
    Engine type : 4 Stroke, Air cooled
    Displacement : 192 cc
    Bore x Stroke : 65 x 57.8 mm
    Compression ratio : 7.8 to 1
    Compression : 142 - 170 psi
    Transmission : 5 speed
    Clutch Type : Semi-auto
    Oil Capacity : 1.43 Qt
    Carburetion : 22 mm Keihin
    Starting system : Recoil Starter
    Fuel capacity : 2.3 Gal , 0.4 Gal res.
    Wheelbase : 46.9 in.
    Overall Length : 72.4 in.
    Overall Width : 42.5 in.
    Ground Clearance : 4.9 in.
    Seat Height : 27.2 in.
    Front Tires : 25 x 12 x 9
    Rear Tires : 25 x 12 x 9
    Front Suspension : none
    Rear Suspension : none
    Front Brake : lever + cable operated drum
    Rear Brake : pedal operated Drum
    Final Drive : chain
    Dry Weight : 299.9 lbs
    MSRP : $1,298.00



    General ATC200M Specifications
    Production Years : 1984-1985
    Engine type : 4 Stroke, Air cooled
    Displacement : 192cc
    Bore x Stroke : 65 x 57.8 mm
    Compression ratio : 7.8 to 1
    Compression : 142 - 170 psi
    Transmission : 5 speed
    Clutch Type : Semi-auto
    Oil Capacity : 1.43 Qt
    Carburetion : 22 mm Keihin
    Starting system : Electric with recoil backup
    Fuel capacity : 3gal with .03 reserve
    Wheelbase : 47.4 in.
    Overall Length : 73.0 in.
    Overall Width : 42.1 in.
    Ground Clearance : 4.7 in.
    Seat Height : 27 in.
    Front Tires : 25 x 12 x 9
    Rear Tires : 25 x 12 x 9
    Front Suspension : Hydraulic Telescoping forks
    Rear Suspension : none
    Front Brake : lever + cable operated drum
    Rear Brake : pedal operated Drum
    Final Drive : Chain
    Dry Weight : 328 lbs
    MSRP : $1,598.00



    General ATC200S Specifications
    Production Years : 1984-1986
    Engine type : 4 Stroke, Air cooled
    Displacement : 192 cc
    Bore x Stroke : 65 x 57.8 mm
    Compression ratio : 7.8 to 1
    Compression : 142 - 170 psi
    Transmission : 5 speed
    Clutch Type : Semi-auto
    Oil Capacity : 1.43 Qt
    Carburetion : 22 mm Keihin
    Starting system : Recoil Starter
    Fuel capacity : 2.3 Gal , 0.4 Gal res.
    Wheelbase : 46.5 in.
    Overall Length : 72.4 in.
    Overall Width : 42.5 in.
    Ground Clearance : 4.9 in.
    Seat Height : 26.8 in.
    Front Tires : 22 x 11 x 8
    Rear Tires : 22 x 11 x 8
    Front Suspension : Hydraulic Telescoping forks
    Rear Suspension : none
    Front Brake : lever + cable operated drum
    Rear Brake : pedal operated Drum
    Final Drive : chain
    Dry Weight : 278 lbs
    MSRP : $1,270.00

    Comments 26 Comments
    1. 2Tim215's Avatar
      2Tim215 -
      Nice link! Thanks...
    1. chrisk121's Avatar
      chrisk121 -
      does any buddy starting point on the 84 200s for carb has keihin has a screw on the side plus needle type screw in the middle going up to the carb body I don't know much about these ol 4 strokes but my kid got this 3 wheeler given to him it is in excellent shape usually starts right up but when you shut it off it wont start again unless you pull plug and clean usually wet when he pulls it out also when choke is on is throttle body flap closed or open thanks
    1. poppanitrous's Avatar
      poppanitrous -
      Quote Originally Posted by chrisk121 View Post
      does any buddy starting point on the 84 200s for carb has keihin has a screw on the side plus needle type screw in the middle going up to the carb body I don't know much about these ol 4 strokes but my kid got this 3 wheeler given to him it is in excellent shape usually starts right up but when you shut it off it wont start again unless you pull plug and clean usually wet when he pulls it out also when choke is on is throttle body flap closed or open thanks
      There is a plastic choke lever on the left side of ATC. put the choke on and see if it idles up or if it dies. Sounds like it is running rich and getting wet or if it is oil then look to rings or valves.
    1. wheelz420's Avatar
      wheelz420 -
      its the first time really trying to start it after putting it back together the guy i got it from gave it a paint job then got sick so i got it cheap but had a lot of work to invest luckily a friend sent me the manual and i got it together in one day. http://www.youtube.com/watch?v=nD5NJfb1FnM
    1. wheelz420's Avatar
      wheelz420 -
      waitin on the ratchets and ratchet springs n clip that all go to the pull rope assembely.should have the money soon to get them then ill be able to test drive it. cant wait
    1. wheelz420's Avatar
      wheelz420 -
      help please !!! anyone???? http://www.facebook.com/profile.php?...v=482342233488
    1. wheelz420's Avatar
      wheelz420 -
      got it goin perfect the needle connected to the throttle line was put in wrong by the previous owner so it would hold it open heres its first running vid http://www.facebook.com/video/video....33488&comments love this thing
    1. mirthgrinder's Avatar
      mirthgrinder -
      Quote Originally Posted by wheelz420 View Post
      got it goin perfect the needle connected to the throttle line was put in wrong by the previous owner so it would hold it open heres its first running vid http://www.facebook.com/video/video....33488&comments love this thing
      Are you addicted Yet???
    1. trikez-youngin's Avatar
      trikez-youngin -
      yeah mine was like that but when i got it back from the shop I still had to roll start it. we fixed it though. its addicting and I love poping wheelies with the touch of the throttle.
    1. wheelz420's Avatar
      wheelz420 -
      my new toy for my honda 200 http://www.facebook.com/photo.php?fb...7788.631043488
    1. wheelz420's Avatar
      wheelz420 -
      100% addicted
    1. zackwhite's Avatar
      zackwhite -
      can any1 give me some help.i got a biek and i think i might have 2 or 3 bikes in 1.the motor it pull and no high or low.isnt that just the atc 200.and the muffler is just over the rear end and i think thats a 200s if im right.that wood make the frame 200s..i just dont n o.and i need some1 to give me some help with clutchs.i dont no how to do them as in set them.
    1. wheelz420's Avatar
      wheelz420 -
      Quote Originally Posted by zackwhite View Post
      can any1 give me some help.i got a biek and i think i might have 2 or 3 bikes in 1.the motor it pull and no high or low.isnt that just the atc 200.and the muffler is just over the rear end and i think thats a 200s if im right.that wood make the frame 200s..i just dont n o.and i need some1 to give me some help with clutchs.i dont no how to do them as in set them.

      http://oscarmayer.net/atc/manuals/ injoy
    1. wheelz420's Avatar
      wheelz420 -
      keep us updated
    1. wheelz420's Avatar
      wheelz420 -
      heres a day vid of mine starting up and doin a few laps round the back yard ,i need to get some 200 plastics for it but the 185s plastic fits it just fine and i also have a extra big red plastic that came with it but looks like hell (needs paint) http://www.youtube.com/watch?v=yvjWpSPNvP0
    1. wheelz420's Avatar
      wheelz420 -
      took it to the street today for a few minutes and hit 3rd gear http://www.facebook.com/video/video.php?v=493512438488
    1. wheelz420's Avatar
    1. MonroeMike's Avatar
      MonroeMike -
      You should start your own thread in Trikesylvania.
    1. wheelz420's Avatar
      wheelz420 -
      oh dude ratfink on a 3 wheeler bomb azz stuff here another vid of me plowin today in the blizzard http://www.youtube.com/watch?v=H6wJ6QHFfCQ
    1. wheelz420's Avatar
      wheelz420 -
      build a plow for a honda atc measurments and video http://www.youtube.com/watch?v=2i44PzOPs54
//ArrowChat Integreation Code //