//ArrowChat Code
  • 3WW Shop Banner

  • Recent Forum Posts

    Supraman0614

    It appears that you are correct that you were...

    It appears that you are correct that you were ripped off by the company that 3D printed that part for you. Surface finishes are a lot better than that, and should not have any lines. You should be...

    Supraman0614 06-18-2019, 08:51 AM Go to last post
    Shep1970

    Just putting this out there, through trial and...

    Just putting this out there, through trial and error bondo doesn’t work well with silicone rubbers or epoxy. If the part were to be sealed with a lacquer first it does better though but not good. Not...

    Shep1970 06-18-2019, 08:32 AM Go to last post
    newby200x

    I have access to a 3D printer at work as well if...

    I have access to a 3D printer at work as well if you need a small part in a pinch. I do new product development for a living, so I work w/ CAD software and 3D Printers daily. Our printer primarily...

    newby200x 06-18-2019, 07:45 AM Go to last post
    200xpensive

    Wtb 86 200x rear fender

    Hey guys, looking for a used rear fender plastic for my 86 200x. Not looking to buy new until I do a full up restoration on it. Anybody got one for sale? Thanks

    200xpensive 06-18-2019, 03:53 AM Go to last post
    ps2fixer

    Here's a screen shot of the 86 range with a...

    Here's a screen shot of the 86 range with a random machine in the middle. Engine serials are a bit all over, the trailboss is right in the middle of all the scrambler engine serial numbers,...

    ps2fixer 06-18-2019, 02:00 AM Go to last post
//ArrowChat Integreation Code //