| 
 Readers Rigs-Page 18
  
Owner:   Dave (Lrd Honda ATC)
Model: ATC250R
 Make:   Honda
 Year:   1986
 Modifications:  
LRD Pipe and Silencer, Brand new OEM Plastic, Westcoast +2 Swingarm, Powdercoated Everything, 
100% restored to HRC specs, everything is brand new. This bike looks like it just came off the show room floor.
 __________________________________________________________
 
 
  
Owner:   Wayde Blackford
Model: ATC200X+ATC200M
 Make:   Honda
 Year:   1985+1984
 Modifications:  
200x theres an Answer pipe, its been bored out to .40, getting new fenders. 
The 200m has an echo tip on it and its been bored out to .40
 __________________________________________________________
 
 
  
Owner:  Curtis Plumton (honda200)
Model: ATC200X
 Make:   Honda
 Year:   1986
 Modifications:  
New Rear Plastics
 __________________________________________________________
 
 
  
Owner:  Curtis Plumton (honda200)
Model: YT175
 Make:   Yamaha
 Year:   1981
 Modifications:  
Painted Green, Doesn't run.
 __________________________________________________________
 
 
  
Owner:  Bill
Model: ATC70
 Make:   Honda
 Year:
 Modifications:  
Paint is House Of Kolor-custom mix Lots of Chrome and Polish
 __________________________________________________________
 
 
  
Owner:  Jaron
Model: YTM200
 Make:   Yamaha
 Year:   1983
 Modifications:  
Stock except for Chain/sprockets, Brakes, and Sheetmetal skidplate.
 __________________________________________________________
 
 
  
Owner:  Jason Laren
Model: ATC250R
 Make:   Honda
 Year:   1985
 Modifications:  
bored, ported, Boyesen reeds, 38 Mikuni TM flatslide, '89 CR 250 head gasket, reed spacer, K&N air filter, 
not sure what the pipe is, it was on it when I bought it, 3" extended swingarm, +2" axle. In this picture the 
forks have Progressive springs but since this pictue I have installed inverted forks from a CR.
 __________________________________________________________
 
 
  
Owner:  Ryan Wilson
Model: ATC185s
 Make:   Honda
 Year:   1982
 Modifications:  
Took down to frame and restored it, most parts were in good condition like
the , gas tank, fenders, engine. The only thing he did to the engine to
make it run was put a carburetor kit in the carb. Cleaned it out put a new
sparker (spark plug) in it and pulled and it ran. Then after riding it a
while he took it down over the summer restored it, glass blasted the parts,
painted em rustoleum red and blue and silver.
 __________________________________________________________
 
 
  
Owner:  Tyler Williams (Tri-Z Pilot)
Model: YTZ250N Tri-Zs
 Make:   Yamahas
 Year:   1985s
 Modifications:  
The silver one has a k&n air filter, 909 handlebars, and a Twist throttle.
The yellow one has a uni pod filter, 400ex Renthal bars, Banshee wheels & hubs, and Banshee thumb throttle.
 Other than that, they are stock.
 __________________________________________________________
 
 
  
Owner:  John Ernest
Model: Big Red 200ES
 Make:   Honda
 Year:   1984
 Modifications:  
Owned since 93, trying to restore it while still enjoying it. Has a buddy molding some Fiberglass
rear fenders.
 __________________________________________________________
 
 
 
 
 |