Readers Rigs-Page 22
Owner: Bruce Hartman (350xin'NY)
Model: ATC250R
Make: Honda
Year: 1982
Modifications:
N/A
__________________________________________________________
Owner: Bruce Hartman (350xin'NY)
Model: ATC350X
Make: Honda
Year: 1986
Modifications:
Front Fender Brace, Maier Disc/Fork Guards, Tach, PRM Grab bar.
__________________________________________________________
Owner: Sean
Model: ATC350X
Make: Honda
Year: 1985
Modifications:
ITP steel rims. 10:1 compression piston,DG Krome Power Exhaust, k&n filter with jet kit,
__________________________________________________________
Owner: Derek Holdren
Model: ATC90
Make: Honda
Year: 1978
Modifications:
N/A
__________________________________________________________
Owner: Tim Keister
Model: Big Red 250ES(X)
Make: Honda
Year: 1985
Modifications:
Kerker Header and Pipe
UNI Filter
Red Frame and Red Seat
__________________________________________________________
Owner: Mike Thurman (Mike Ft Laud)
Model: ATC200R (Modified 250R)
Make: Honda
Year: 1985?
Modifications:
HRC Short track kit, modified cylinder and crankshaft to reduce stroke down to 200cc's,
custom 200cc pipe, Front number plate, 200R seat cover.
__________________________________________________________
Owner: Mike Thurman (Mike Ft Laud)
Model: ATC200X
Make: Honda
Year: 1985
Modifications:
Bills Pipe, Vented front fender, Low profile rear fenders.
__________________________________________________________
Owner: Ted Peterson (eh_Tee_See)
Model: ATC250SX
Make: Honda
Year: 1985
Modifications:
Cobra pipe, 350x carb, and a vented air box lid.
__________________________________________________________
Owner: Nathan Gibbons (03 Orange Shee)
Model: YTZ250N Tri-Z
Make: Yamaha
Year: 1985
Modifications:
Wrench report mods, Raptor rear shock,10 inch rear Banshee wheels/hubs, DG national pipe,
86' 250r 34mm. carb with uni filter on carb.
__________________________________________________________
Owner: Ben
Model: ATC250SX
Make: Honda
Year: 1986
Modifications:
+7 swing arm and drive shaft for it. He put some longer forks from a CB750 bike.
He also made some linkage suspension with the stock shock.
The linkage gives it 9 inches of travel. Motar work is a 60 over bore, hot cam from james lucky, Jetting, pipped, and a custom air box.
__________________________________________________________
|