Readers Rigs-Page 18
Owner: Dave (Lrd Honda ATC)
Model: ATC250R
Make: Honda
Year: 1986
Modifications:
LRD Pipe and Silencer, Brand new OEM Plastic, Westcoast +2 Swingarm, Powdercoated Everything,
100% restored to HRC specs, everything is brand new. This bike looks like it just came off the show room floor.
__________________________________________________________
Owner: Wayde Blackford
Model: ATC200X+ATC200M
Make: Honda
Year: 1985+1984
Modifications:
200x theres an Answer pipe, its been bored out to .40, getting new fenders.
The 200m has an echo tip on it and its been bored out to .40
__________________________________________________________
Owner: Curtis Plumton (honda200)
Model: ATC200X
Make: Honda
Year: 1986
Modifications:
New Rear Plastics
__________________________________________________________
Owner: Curtis Plumton (honda200)
Model: YT175
Make: Yamaha
Year: 1981
Modifications:
Painted Green, Doesn't run.
__________________________________________________________
Owner: Bill
Model: ATC70
Make: Honda
Year:
Modifications:
Paint is House Of Kolor-custom mix Lots of Chrome and Polish
__________________________________________________________
Owner: Jaron
Model: YTM200
Make: Yamaha
Year: 1983
Modifications:
Stock except for Chain/sprockets, Brakes, and Sheetmetal skidplate.
__________________________________________________________
Owner: Jason Laren
Model: ATC250R
Make: Honda
Year: 1985
Modifications:
bored, ported, Boyesen reeds, 38 Mikuni TM flatslide, '89 CR 250 head gasket, reed spacer, K&N air filter,
not sure what the pipe is, it was on it when I bought it, 3" extended swingarm, +2" axle. In this picture the
forks have Progressive springs but since this pictue I have installed inverted forks from a CR.
__________________________________________________________
Owner: Ryan Wilson
Model: ATC185s
Make: Honda
Year: 1982
Modifications:
Took down to frame and restored it, most parts were in good condition like
the , gas tank, fenders, engine. The only thing he did to the engine to
make it run was put a carburetor kit in the carb. Cleaned it out put a new
sparker (spark plug) in it and pulled and it ran. Then after riding it a
while he took it down over the summer restored it, glass blasted the parts,
painted em rustoleum red and blue and silver.
__________________________________________________________
Owner: Tyler Williams (Tri-Z Pilot)
Model: YTZ250N Tri-Zs
Make: Yamahas
Year: 1985s
Modifications:
The silver one has a k&n air filter, 909 handlebars, and a Twist throttle.
The yellow one has a uni pod filter, 400ex Renthal bars, Banshee wheels & hubs, and Banshee thumb throttle.
Other than that, they are stock.
__________________________________________________________
Owner: John Ernest
Model: Big Red 200ES
Make: Honda
Year: 1984
Modifications:
Owned since 93, trying to restore it while still enjoying it. Has a buddy molding some Fiberglass
rear fenders.
__________________________________________________________
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 16
Page 17
Page 18
Page 19
Page 20
Page 21
Page 22
Page 23
Page 24
Page 25
Page 26
Page 27
Page 28
Page 29
Page 30
Page 31
|
