hey guys, im considering a atc 250r powered cr 500 motor conversion. most likely an 80's model 500 motor (85 and up), and i was wondering how bad it would be to modify a pipe for it....ill upload pics of the build
hey guys, im considering a atc 250r powered cr 500 motor conversion. most likely an 80's model 500 motor (85 and up), and i was wondering how bad it would be to modify a pipe for it....ill upload pics of the build
The cut and twist method is the easiest way unless you want to start from scratch.
3wheelers I own now: 86-ATC500R 86-KXT500 87-KXT250
Check out my 3wheeler videos on youTube Lazybiker79
http://www.youtube.com/watch?v=UNy9k...qljTifaAX47-6w
should i start with a fatty or PC pipe?
Read up on those exhaust and see what power they put out and how they change the power.. Everyone likes there own exhaust.
3wheelers I own now: 86-ATC500R 86-KXT500 87-KXT250
Check out my 3wheeler videos on youTube Lazybiker79
http://www.youtube.com/watch?v=UNy9k...qljTifaAX47-6w
i see,thanks..with all the botomend,,i want a pipe for topend or mid range..a cr 500 i think has enough bottom lol
There a little hard to control if you want all top end. But thats the fun of it...
3wheelers I own now: 86-ATC500R 86-KXT500 87-KXT250
Check out my 3wheeler videos on youTube Lazybiker79
http://www.youtube.com/watch?v=UNy9k...qljTifaAX47-6w
yup! what did you have?
FMF Gnarly
3wheelers I own now: 86-ATC500R 86-KXT500 87-KXT250
Check out my 3wheeler videos on youTube Lazybiker79
http://www.youtube.com/watch?v=UNy9k...qljTifaAX47-6w