First Time Rider
Arm chair racerNew to the board
ok guys,
past few days been tearing down the bigred.
here is where it sits now,
it got the tire.lest then a year old to.
here the tank
[URL=http://s297.photobucket.com/user/Reaper351/media/DSCN9122.jpg.html][/URL
next few days we are going to pressure wash the frame.and tank sand the tank to the metal.
tank looks pretty bad i know.
score a transmission set for it for 35 bucks shipped.couldnt past that put
Dirty Main jets are my bane.
4 Wheels? Huh?
See anything you need? Pay for shipping and a few bucks for a soda and ill mail you what ever you need off this bike if i still have it. That is a very sicking thing to see man
An F-16 turned the after burners on and banked HARD over my house, I ran outside grabbed my Bud Light and Yelled as loud as I could................
GIT IT RAG!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
"MR.Clean"
New 10 inch wheel buy http://www.3wheelerworld.com/showthr...12#post1258412
Power User
Got the holeshot
Good luck with the rebuild.
I could be geriatricdog... at my age
Got the holeshot
It is looking better already! Just getting the melted body work off of it helped a lot. Still got that airbox if you need it, and could probably find a few other goodies to donate as well.
Last edited by tripledog; 08-28-2014 at 11:21 PM.
First Time Rider
Arm chair racerNew to the board
thanks for the offer,but i think we have gotin all the parts to get it back into shape.Originally Posted by tripledog
now questions.
ever since we have had the 3wheeler the driveshaft boot has been busted.we plan on takeing the swing arm out and replace it.
the problem is.we dont know how to get it off.
we found the bolt that holds it on.but it hasnt seen daylight in about 20 years it looks like.how do we take it out? anyone got any pictures or what not.
the right side has the night on it.but its all rusted and crap.i can get pictures if needed.
First Time Rider
Arm chair racerNew to the board
hey guys,dose anyone have any wireing dirgrams or pictures of the wireing harness with tags with what gose were?
we have a wireing harness and i know where the front of the harness gose but when it gose to the back,i have no clue where what gose were.
First Time Rider
Arm chair racerNew to the board
update!
we got the swing arm out. driveshaft and diff are still tight no slack.
we pressure washed the rear end.and cleaned the drivshaft tube.
gas tank is striped and ready for some paint.
its getting there.cannot wait to have it running again.
Reply With Quote