//ArrowChat Code
Results 1 to 4 of 4

Thread: '80 honda atc 110 lights issue

  1. #1
    Join Date
    Apr 2015
    Location
    Abilene Tx
    --
    11

    '80 honda atc 110 lights issue

    I've connected a toggle switch to my head and tail light. The first time I connected the wiring I got the headlight to work but not the brights and no taillight. I worked on it a bit more and got the taillights to work but no headlight at all. Again, I've toyed with it and now my taillights are out. Please help. It's driving me nuts. Maybe a short in the wiring or maybe not enough power to light everything up? I don't know enough to figure it out. Thanks in advance.

  2. #2
    Join Date
    Jul 2009
    Location
    South Florida
    --
    6,722
    First off it's a 6 volt system and their is no regulator so the bulbs are the resistor , make sure you have the correct bulbs , if you try and run just the tail light with out the headlight it will burn out in a few seconds .
    78 atc 90/180cc Dickson Full Suspension
    76 ATC90/180cc Nicholson
    77 atc 90 Dickson Full Suspension
    84 KLT 110/123cc Powroll Racer from 80s
    87 atc 125m stock
    84 atc 200x Curtis Sparks
    84 atc 200x Powroll My race bike from 80's
    83 atc70/108cc Powroll blue Xmas Special
    81 atc185s HP-ATC full suspension

    Performance Shop is Open PM me for Service

    My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10

  3. #3
    Join Date
    Apr 2015
    Location
    Abilene Tx
    --
    11
    Quote Originally Posted by shortline10 View Post
    First off it's a 6 volt system and their is no regulator so the bulbs are the resistor , make sure you have the correct bulbs , if you try and run just the tail light with out the headlight it will burn out in a few seconds .
    Probably answers why the taillight quit working. But what's with the headlight? Maybe the little contact points aren't matched between bulb and socket? With this headlight, I just drop the bulb into the housing and then connect the socket to it. Maybe they aren't making contact.

  4. #4
    Join Date
    Apr 2015
    Location
    Abilene Tx
    --
    11
    I'm still needing help. I have power to all wires when connected to the switch. I checked with a voltage sensor. But the headlight doesn't light up when connected to the socket assembly. Could that assembly possibly go bad? The power seems to be stopping there.

//ArrowChat Integreation Code //