Hey all I just got what I was told was an extended 200x axle. After some googling I found out it's an 82r axle. My question is how long are the stock axles end to end, this one measured out at 39.5 I ask so that I know what I have here thanks,
Hey all I just got what I was told was an extended 200x axle. After some googling I found out it's an 82r axle. My question is how long are the stock axles end to end, this one measured out at 39.5 I ask so that I know what I have here thanks,
Just got a pic to upload
Sent from my LGL34C using Tapatalk
Looks like a +6" 200x axle to me . It will work on an 82r if you use the 200x sprocket set up .
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10
Thanks short line. Based on measurements I provided durablue yesterday I believe it's one of there's
Sent from my LGL34C using Tapatalk
If it requires hub spacers then yes durablue . Could also be a finishline , maxtrax or NASA
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10
Went out to check it and it doesn't require spacers. Again.thanks for the help
Sent from my LGL34C using Tapatalk
Was finally able.to load these close up pics of the axle. Dang phone takes forever
Sent from my LGL34C using Tapatalk
It looks like a NASA. I have both a Durablue and NASA for an 82 250 r plus a NASA for my 81 250 r. And your axle looks like my NASA . Do you have the hub nuts.
250r rules
No how it's in pics is how I got it.
Sent from my LGL34C using Tapatalk
[QUOTE=flynfish;1378892]No how it's in pics is how I got it. Have extra 200x sprocket hub and axle nuts and they slid on with no slip or slop.
Sent from my LGL34C using Tapatalk
Atc300r. I would appreciate any other information you could give on this axle. Tried googling them and nothing. Thanks
Sent from my LGL34C using Tapatalk