Need to change the sprocket shaft seal any way to access it without pulling the entire side of the engine off?
Need to change the sprocket shaft seal any way to access it without pulling the entire side of the engine off?
proud owner of a trx300ex quad and an 85 atc 70
no there's not
NO. the sub-trans must come off. be VERY careful when doing so and make sure BEFORE you do this, you source a sub-trans gasket. they are VERY hard to find. I have 2. one for my 200ES I am redoing and one for the 200E that needs it's old one replaced. So I do not have a spare. they are hard to find. Good luck.
BTW, 200E and 200ES use the SAME sub-trans gasket.
________________
I'm just a squirrel "Trying" to get a nut!
Nearly every kind of Honda ATC (plus some custom ones
several Yami Quads (mostly custom built for MX racing)
https://www.mikesatvfix.com
"Freedom is not free...but the U.S. Marine Corps will pay most of your share."
Ok got a new seal installed on the engine side but the subtrans seal is discontinued anyone know where to aquire one?
proud owner of a trx300ex quad and an 85 atc 70
ebay. spend your time searching ebay. one will come up eventually. also post in the classifieds asking for one.
if your "good" and brave enough, you could get gasket material same thickness as stock and make one but that will be a bit tough as it is pretty skinny in spots.
________________
I'm just a squirrel "Trying" to get a nut!
Nearly every kind of Honda ATC (plus some custom ones
several Yami Quads (mostly custom built for MX racing)
https://www.mikesatvfix.com
"Freedom is not free...but the U.S. Marine Corps will pay most of your share."
Got it running now i hear a distinct knocking from the engine seems to be quiet at idle but with throttle its there but at steady speeds its not there. In gear or not... rod bearing? Didnt find any metal in the filter
proud owner of a trx300ex quad and an 85 atc 70
It also has the spinning sound then clunk after its been shut off
proud owner of a trx300ex quad and an 85 atc 70