Think i have to pull my top end as i checked compression and it was down down down! Can i pull the cylinder without removing the engine? thanks
Got The Holeshot
Arm chair racerJust too addicted
Think i have to pull my top end as i checked compression and it was down down down! Can i pull the cylinder without removing the engine? thanks
86 350X ::: 85 250R
Projects
350x
Come and Gone
86 350x : 84 250r X2
85 350x X2 : 84 200es X3
83 200e : 78 ATC90
Got The Holeshot
Arm chair racerJust too addicted
Super350, I'm not sure mate, but I can confirm that the barrel can be taken off most two strokes in chassis. I had a look at some pictures on line, and I have no reason to believe the YT175 would be any different.
In service replacement of pistons and rings on two stroke motors is virtually mandatory. I believe engineers would have allowed room in the frame for this to occur.
I would give it a go, if you get stuck. Take some pictures and post them up and I'll talk you through the process. Taking pictures is a good idea every time you pull apart anything. It allows you to cross check the location of things when it comes time to reassemble.
As long you take a methodical approach to this I'm sure you'll be fine.
Sent from my iPad using Tapatalk
My toys 85 KXT250A2, 85 ATC250R, 85 Tri-z 250, 06 LT-R450, 04 YFZ450S, 07 125 typhoon x 3, 06 FPV GT.
Got The Holeshot
Arm chair racerJust too addicted
I know for a fact you can do it on the ytm 125. It's snug but I've done it multiple times.
Got The Holeshot
Arm chair racerJust too addicted
right on, thanks guys!
86 350X ::: 85 250R
Projects
350x
Come and Gone
86 350x : 84 250r X2
85 350x X2 : 84 200es X3
83 200e : 78 ATC90
Reply With Quote