I have a 1986 TRI-Z with white front fender. On the front of the fender is a FOX Racing logo. This is not a decal. It is not pressed into plastic it sits higher than flat surface and is part of the plastic. Any info about this is appreciated.
I have a 1986 TRI-Z with white front fender. On the front of the fender is a FOX Racing logo. This is not a decal. It is not pressed into plastic it sits higher than flat surface and is part of the plastic. Any info about this is appreciated.
That fender was deteriorated by the sun and the decal protected the plastic underneath it causing a raised effect.
Sent from my SM-G900V using Tapatalk
'86 ATC 250R, Build Thread http://www.3wheelerworld.com/showthr...highlight=250r
'86 "Factory Tri racing" Tri-Z http://www.3wheelerworld.com/showthr...b-Top-Tank-ect
Pile of Tecate Parts
My Feedback Thread: http://www.3wheelerworld.com/showthr...edback-for-bkm
Yes same thing happened to my kids mini quad.
Sent from my XT1080 using Tapatalk
85 Tri-z Power valve on Inverts
85 Tri-z Basket Case
01 gsxr750 engine/Tri-z frame (long long way from complete)
Yeah bkm is right. Anyone know a way to remove that?
I don't know why you'd want to but you could sand it off.
85 Tri-Zinger 60
85 ATC250SX
86 ATC250SX
87 ATC250SX
02 XR650L conversion
84 ATC 480R
All above are correct answers. Steelwool and brake fluid will work also. I have ufo on my yz fender sun fades and shrinks plastic when exported to long term light.