Welcome,
It's pretty hard to tell from your pic where the oil is coming from. If it's a seal you will need to pull that side cover off and replace it, don't forget to order any other gaskets you will need when you put it back together.. Post another pic with some sort of mark on the excact spot of the leak, that will help narrow it down..
I might have to much oil in there. Is oil even supposed to be on this side .? Ill try to get some better pics tomorrow also , eventually im going to have to do the top end and replace anything leaking .
Oo i hope mines not to badly messed up if it is in there but it still starts up on first 1-3 pulls but thank you for your help
From what I can tell by your pictures, it looks like the crankcase breather to me.
Looks like the stator wires to me , need to remove the cover , purchase a new gasket , clean it up real good and seal it with hondabond
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10
Hey bubbles sounds like you could benefit from a manual if you are getting that far into things.. it would explain things better than we can through this forum.. plus there's pictures.