can I run a bear claw tire up front with 200x front end,or is it to wide and will rub?want to run bear claws in back what are the sizes??
can I run a bear claw tire up front with 200x front end,or is it to wide and will rub?want to run bear claws in back what are the sizes??
Last edited by vanvranken; 12-01-2017 at 10:10 PM.
The stock front tire for the 200X is a 23.5x8-11. If you can find a Bear claw in this size, it should work fine. The rears on both machines were 22x11-8 stock. If not, there has been a few people who have put a 10" rim on the front of their 250R. Maybe this could work on a 200X front end as well.
having trouble locating a aluminum front rim??
What size? There's several stock ones on Ebay right now.
Looking for a new aluminium one .
Call Douglas rims , they sell new ones I have one both 11” and 10” for my 350x , same volt pattern offset etc as the 200x. Also check ebay there’s a guy in so cal who usually has them in stock. That’s where i bought my 11” one from.
Sent from my iPhone using Tapatalk Pro
I found the rim on ebay.listing says it fits 350x,200x,250r.i tried my 85 200x hub on a 86 250r front rim I have don't fit????
That’s strange. I was under the impression they were the same. I was even told the rims I had on my 350x were OEM 200x wheels, wich made sense cause they didn’t look the same and the tears were 8”.
Sent from my iPhone using Tapatalk Pro
Everything I’ve read said they swap. Maybe you have the wrong hub. Idk. Measure it center of stud to center of stud then multiply by 25.4 , should be 170mm , at least that’s what I’m reading.
So there might be a difference from 85 to 86 on the hub and wheel. I’m reading the 85 is 4 on 176 and the 86\87 is 4 on 170. Hopefully someone can verify. I don’t own either bike. Only a 350x good luck
Sent from my iPhone using Tapatalk Pro
Last edited by Shawn Powell; 12-03-2017 at 10:44 PM. Reason: Typed wrong. Fat fingers
help anyone???