Originally Posted by
shortline10
Wouldn’t hurt to use some valve lapping past to reset the flywheel on the crankshaft. Just put a generous amount on both the shaft and flywheel keyway areas , rotate back and forth until the surfaces look mated .
A good snug / mated fit is very important or it will sheer again .
That's a nice little trick Shortline, never considered that
90 nickolson Bored and Stroked "The Good"
Big Bore 110 Pauter frame "The Bad"
90 Bored and Stroked “vey’s frame” "The Ugly"
110 JSC frame Bored and Stroked
flat track build. “Shop trike”
1974 original 90 X 2
1974 Original 70.