Ok guys new to the forum but need some guidance. I just recently put together my old 1985 atc 200x. I went completely through the top and bottom end. New seals, new kickstart ratchets, new gaskets. I replaced the ignition and lighting coils with ricky stator ones new. New ebc clutch with 10% extra power springs. The jug. The cylinder is bored to 66mm, wiesco 12.1 to 1 high comp piston. Then installed new valves, lapped for the head, and installed a web camshaft 214 profile cam with performance valve springs. All new gaskets on the top end. Reassembled and set the valves according to spec. Set the pulse generator to .012 according to the book. So after getting everything back togather tested it. The compression is 120-130 psi. However I cannot get it to start or hit over. I tried to see if i had spark but I cannot verify it so far. The carb has a 132 main jet in it, and fuel is getting to the carb, runs out the drain when you turn the drain screw. The carb is also completely clean inside, went through it before reinstalling it. I also tried to spray a little ether in it to see if it was a fuel issue, but still no hit over. I have kicked this thing until my foot is sore. So what do you guys think. Where should I look next? I checked my wiring and everything appears good, no loose , or damage. Im stumped, and any help would greatly be appreciated.