What does the Manual say the tolerance should be?
What does the Manual say the tolerance should be?
Liberalism suspends the intellect of its victims, while at the same time tricking them into believing that they're smarter than everyone else.
If we've done business together, please leave me feedback. Thank You!:
http://www.3wheelerworld.com/showthr...t=Scootertrash
I was born and raised on Venus & I may be here a while.....
I would put it in the middle of spec if it was me. 0.006" should be great.
1984 HONDA ATC200M - OG, mid-restoration
1981 HONDA ATC200 - future build
1981 HONDA ATC185S - parts
1984 ATC200X - roller, future build
1984 Honda ATC250r - in a million pieces- ISO grab bar, PM if you have one
Da velder
_______________________________________________
Feedback:
http://www.3wheelerworld.com/showthr...ck-for-Barnboy
If I were you I'd have Glamy measure your crank.
85 Tri-Zinger 60
85 ATC250SX
86 ATC250SX
87 ATC250SX
02 XR650L conversion
84 ATC 480R
Again, that is within spec for an ORIGINAL honda rod, and that is still on the tight side and would likely be covered under the warranty if it seized when the vehicle was new, but you seem to know best.
No I certainly don’t! Lol!!
It does make sense to have a little more clearance. I’m just being a whiny betch about it because it’s running true as is.
Hopefully I can put a little pressure on it and not “move it”.
Last thing I want is to regret being lazy. Been there. Done that.
I will see if I can get it to .005-.006 without mucking it up.
Thanks guys.
I was born and raised on Venus & I may be here a while.....
[QUOTE=Gabriel;1491862]
I will see if I can get it to .005-.006 without mucking it up.[QUOTE]
Do you have a strong plate with a slot in it to press it apart some?
I do. I made one just for pressing it apart. I think I will set it up in the press (when i can get back to the press) with a dial indicator zeroed on the crank journal to monitor movement. Seems the safest route.
I was born and raised on Venus & I may be here a while.....
I realize you’ve already done the crank, but do you have pictures of your fixtures in use? How thick is the plate you made to separate the crank?
Pics on page 1
Plate is 3/8” thick
I was born and raised on Venus & I may be here a while.....