New to the board
Arm chair racerNew to the board
I picked up a Honda 200m front end that will likely end up on my 200ES. I've run into an issue... I've removed the axle holder, but I cannot remove (or figure out) how the front axle slides out. It's either seized up or I am doing something wrong. How does the from axle come out? Does it slide out or does it need to turned out? Your help is appreciated.
Just Too Addicted
Arm chair racerJust too addicted
Should have a hex on the left side for a 18 or 21mm socket...forget the size. Anyway it should just unscrew.
1984 HONDA ATC200M - OG, mid-restoration
1981 HONDA ATC200 - future build
1981 HONDA ATC185S - parts
1984 ATC200X - roller, future build
1984 Honda ATC250r - in a million pieces- ISO grab bar, PM if you have one
Da velder
_______________________________________________
Feedback:
http://www.3wheelerworld.com/showthr...ck-for-Barnboy
New to the board
Arm chair racerNew to the board
I've seen them stick in the bearing. Try some penetrating fluid, heat, and patience.
Reply With Quote