//ArrowChat Code
Results 1 to 3 of 3

Thread: 1980 ATC 110 Electrical Help

  1. #1
    Join Date
    Feb 2015
    Location
    indio, ca
    --
    19

    1980 ATC 110 Electrical Help

    I keep blowing bulbs, and I am stuck on the solution..... I checked the grounds all seem to be good. When I check the front bulb socket, at idle I get 11 volts ac. If I rev it, it will go all the way to 30 volts ac. any help appreciated

  2. #2
    Join Date
    Jul 2009
    Location
    South Florida
    --
    6,722
    It’s a 6 volt system unregulated , meaning the bulb is your resistor .
    Try grounding from the motor and using an analog meter for testing , could be as simple as a bad ground .
    78 atc 90/180cc Dickson Full Suspension
    76 ATC90/180cc Nicholson
    77 atc 90 Dickson Full Suspension
    84 KLT 110/123cc Powroll Racer from 80s
    87 atc 125m stock
    84 atc 200x Curtis Sparks
    84 atc 200x Powroll My race bike from 80's
    83 atc70/108cc Powroll blue Xmas Special
    81 atc185s HP-ATC full suspension

    Performance Shop is Open PM me for Service

    My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10

  3. #3
    Join Date
    Feb 2015
    Location
    indio, ca
    --
    19
    turned out to be a wire on the light switch came un soldered , fixed. thanks

//ArrowChat Integreation Code //