I picked up a 200X cylinder from a local guy. It was a fresh over bore 65.5mm
Measured 2.5762-2.5765
Ordered a new Wiseco and the piston skirt measures 2.576-2.5761 at it largest point.
Well FACK!!!!!
I just ordered a new a flex hone of appropriate size. I'm hoping to be able to get .002 or so worth of material out of there for proper clearance. Is this possible without screwing it up?
THIS is what you get when you DON'T have a shop fit the piston to the bore at the same time. *sigh*
It's always SOMETHING!!!!!