I am closing in on my 200x build, however I have purchased a mikuni 28mm carb for it and I need the intake manifold that converts it to a spigot type carb.
Thanks in advance.
I am closing in on my 200x build, however I have purchased a mikuni 28mm carb for it and I need the intake manifold that converts it to a spigot type carb.
Thanks in advance.
"I'm Watchin' The Herk N' Jerk!"
3&2moto on YouTube
Trikefest 10,17,18,19
There's quite a few ways to attack this, not sure if the length is also an issue??
Anyhow, that's just a few MM's above stock, in the past I have use my dremel with a large sanding disc on it and carefully went in circles to bore it out enough; You have to be good with hand/eye coordination...
Honestly tho, Shortline10 is your best bet, he's the 1st gen 200X master....
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country