Got The Holeshot
Arm chair racerJust too addicted
Does anyone know what a 250ES exhaust gasket measures on the ID?
I have a 300EX on hand and it measures 1.365. It might work but is a little loose for my liking. Looking for a donut ring that's about 1.25 ID.
For all I know the Honda 200 gasket may be the right one but I used the last one I had and haven't ordered more.
If you have one laying around, please measure it and let me know. Thank you!!
Last edited by Gabriel; 06-10-2019 at 06:06 PM.
I was born and raised on Venus & I may be here a while.....
Power User
Roostin Away
86/87 200x- is this:not sure it’ll help but u can compare part #’s
If it the gasket your looking for/ just remember the soft copper squishes so the one you have will most likely be fine.
Shep
Power User
The day begins with 3WW
If you don't mind china made for this part, I can get them pretty cheap. I could grab a hand full of them in my next order if you want. Ironically, this company does somewhat good giving dimentions and such, everything is in mm though, 32mm = 1.25984in. They have smaller that's under 1.25in too, and even smaller yet. I suspect the best measurement you'd need is the exhaust flange that you're trying to seal, so the ID's don't interfere with the exhaust flow.
32mm ID
http://www.motopartsdealer.com/exhau...le-p-1614.html
30mm ID
http://www.motopartsdealer.com/exhau...le-p-1612.html
Reply With Quote