Hey yall new member here from the deep south Baton rouge, Louisiana. First I would like to start off by saying I am honered to be part of such an awesome trike forum there is a wealth of knowledge to be had here. I have an 84 200s I am in love with the bike that being said I would like to keep it and make it fully suspended I work in a machine shop I can machine, weld, and fab everything I need such as the swingarm shock mounts basically anything have a full machine shop here but I really hate to have to tear my bike down and not be able to ride for an extended period of time. So I guess my question is does anybody that has built their own swingarm have any dimentions they would be willing to share with me. Sure I could tear it down and with some trial and error figure it out but figured I would ask first before I did all that. I have searched the internet and have not ran across any. All help would be appreciated. I am going to be using chromoly and tig welding it with er70s-2 filler rods and am shooting for about a +2 swingarm. I will also be using the 450 hubs for a little wider stance and better options for rims and tires also a complete teardown to frame, better clutch and a complete top end rebuild. Might spice the motor up a little with a higher compression piston, mild cam, a not to obnoxius exhaust, and a little port matching and polishing. This is an awesome site I am on here almost everyday searching through the archives trying to learn all I can about these pieces of history I am going more for a restomod build make it look a little more modern. Thanks guys yall really seem like a great group of people full of knowledge and I hope to learn alot more from you guys.