Tried removing my choke plunger in the carb and broke the needle off on the end and it won't come out what's my solutions here.
Tried removing my choke plunger in the carb and broke the needle off on the end and it won't come out what's my solutions here.
Sometimes you can drill the center of the plunger and use an easy out and a little heat around the case at the plunger will help . Lots of penetration fluid .
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10
Just reread your post , if it’s the tip of the plunger that’s stuck then your probably best to find a new carburetor .
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10