Currently : trx400fw, ct70, 250es,200x, xl80s, 350x, 350x, 225DX, trx300
The motor might be on the verge of over heating and just melting it .
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10
Check to see if your exhaust is not plugged up, I had a car with a plugged cat and it did the same thing repeatedly till I opened it up. uhh I meant replaced the cat.
No trike left behind
1983 Ytm 200
1983 Honda 200
1982 Honda 185s
1983 odyssey fl 250
1987 yz 250
It almost looks torn, not melted. Do you have any pictures of it NOT in the bike?
RIP - Yamahondaman!! You will never be forgotten!
RIP - Sam Brehm!! Gone but NEVER forgotten!
RIP - Sandpuppi101 - You will live on in my mind - I miss you friend!
this pictures is of it uninstalled. It was fine when it went on, but after the bike was run and left for a few hours, the hole was present. i tried some epoxy to fill it, but that failed, it started, but had major vacuum leak and idles at about 3/4 throttle. i'll look into the clogged up exhaust, i was with a friend in his 1988 CR-X when the cat go so hot, that it could not flow anything and it shut down the engine because of lack of flow. (we were going faster than the speedometer could register.....)
Currently : trx400fw, ct70, 250es,200x, xl80s, 350x, 350x, 225DX, trx300