I am putting my big red back together finally. My starter gears teeth were broken due to the bad one way bearing. I have replaced the one way bearing and am trying to put the right side crankcase cover back on and ran into a problem. I can't figure out how to install the spring that goes on the arm that the reverse cable connects to. I have read a few post about this but still at a lost. I put it back together but when pulling the cable, it doesn't move. I think I see how the reverse lever works but can't seem to figure out how the spring fits on to make the cable work. Does anyone have a picture of the side cover off with the reveres arm and lever in place or any advice? I have tried to install the arm, spring and lever in the engine before installing the cover.