I have looked through the manual but can't find the answer.
Do I have to remove the entire engine to do a top end rebuild?
Thanks
MrC.
I have looked through the manual but can't find the answer.
Do I have to remove the entire engine to do a top end rebuild?
Thanks
MrC.
Nevermind.
Mrc.
Yes, you do.
1984 HONDA ATC200M - OG, mid-restoration
1981 HONDA ATC200 - future build
1981 HONDA ATC185S - parts
1984 ATC200X - roller, future build
1984 Honda ATC250r - in a million pieces- ISO grab bar, PM if you have one
Da velder
_______________________________________________
Feedback:
http://www.3wheelerworld.com/showthr...ck-for-Barnboy
Some of them you can pull the long studs and do it in the frame, but they all vary...
All our government does is distract us while they steal from us, misspend our tax $ and ruin our country
not much work to pull an engine out
After asking the question, I went out and pulled the engine, it was a lot nicer to work on at the table than in the frame, my back isn't what it use to be.
I did a top end and she is back together, chasing a carb issue now.
Thanks for the help.
MrC.