ATC110 Ignition Coil Wiring

[MastaFlyMason]

Hi! I have an ATC110 and I'm trying to use an aftermarket ignition coil on it. It has 2 male spade terminals on it (one green one black) Looks like on the bike I have 2 wires (one yellow one black) coming out of the stator and one wire coming from the ignition system. How would I go about wiring this up. Thanks!

[DAM shop]

There is a wiring diagram on this site you should be able to access. The yellow is for your lights. So if you eliminate that for now and hook up the other two leads you should be able to test for spark.

[shortline10]

What year 110 ? CDI or points model ?

[MastaFlyMason]

I'm not sure what year it is but I opened up the cover and it's a points ignition. How do I hook up the other two leads? Sorry I don't fully understand where they would go. If one is a lighting output then there is only one wire to the stator and then two other wires that I think need to be hooked up

[shortline10]

You need an original 6 volt coil with the capacitor attached to it , if your trying to use an aftermarket 12 coil it won’t work .

This is the correct coil for a 79/80 Atc110 , seller has no clue what their selling lol but it’s the right one .
Very good price , these usually go for crazy money .
https://www.ebay.com/itm/GENUINE-HON...8AAOSwCOheAqfq

[MastaFlyMason]

I tracked down the OEM one, any advice on how to wire this one?

[shortline10]

Black wire from stator goes to the coil wire and the points wire also connects to that same coil wire . It’s that simple , if you still have the original harness ?

[MastaFlyMason]

Yep I have it all just double checking. Thanks!