My feedback link
http://www.3wheelerworld.com/showthr...edback+troyg25
How easily does that plate washer spin? Issue I have now with it bolted back together is pulling the rope does not create enough force to spin the plastic piece out. Is there a washer or anything that goes with the bolt that holds it together?
No washer at all. Is the bolt to long? Is the plastic housing sitting flush with the bolt hole?
Hard to see what's going on.
My feedback link
http://www.3wheelerworld.com/showthr...edback+troyg25
Messed with this some more yesterday. Tried rewinding the spring, cleaning up the whole assembly so it was clean, polishing the plastic parts with steel wool, smaller bolt. washers on both sides of the plate. And only way I can get the arm to swing out is if I do NOT use that little spring that helps push the arm back in. So tried it a few times without the spring and seems to be fine. Seems odd that the spring would get stiffer all of a sudden after working fine for years..
My feedback link
http://www.3wheelerworld.com/showthr...edback+troyg25