Can't believe it's been so long for an update! This has definitely been a marathon thus far with a few u-turns added for good measure
The brakes went together well and I even made a custom adjustment tool to help out. I'm trying to solve some very pesky leaks at the copper crush gaskets even though it's all new components....I've ordered more parts so I'll get it eventually. Let's talk springs.....I had the springs re-arched in Edmonton and have a bit of a dilemma. You can see the device I made to pre-load the springs so I can bolt up the shocks and brake lines. Then I can slowly unload them later on by loosening the nut. I've reached out to a few brethren from a military vehicle forum and am assured this is quite normal until the major components are installed to add weight. It's a bit unnerving is all. I'm in the process of going through the tranny and t-case for serviceability, seal them up and hopefully get them painted soon. The motor is being re-assembled as we speak so I may see it soon too! I have a target of end May to be driving this thing again so the race is on!