So after heat, beat, chisel, repeat, I finally got what was left of my swingarm bearings out. This was all there was. Just the outer cage of the needle bearing . That's it. Nothing else was in there. Needles to say it was a bit over due. So now look at this. Do I need a new swing arm? I can drop the bearing right into one side. No pressure needed. It just falls in. I'm guessing a new swingarm is on order. Saw a fairly nice refurbished one for $325 on eBay. Is that my best bet or can this one be salvaged? I'd rather not have to shell out the $325 right before Christmas. Thanks for the input.