That's looking pretty good.
Someone could put a little elbow grease into that, with some hand sanding, and have it smoothed out pretty good.
Are the mounts there for the inside nuts?
That's looking pretty good.
Someone could put a little elbow grease into that, with some hand sanding, and have it smoothed out pretty good.
Are the mounts there for the inside nuts?
The story of three wheels and a man...
Yes and the insert for the nut on the flange
How long did that take to print ? You try the Isotoner to help smooth it out yet ?
If its on the internet its got to be true they can't put any lie's on the internet
~17hrs. I haven't used isotoner, isn't that for abs only? This is pla. It is actually really smooth and can barely see the print lines. Pictures for some reason, show print lines that aren't seen as easily by the eye.
I’m pretty sure it works on pla too.
If its on the internet its got to be true they can't put any lie's on the internet
It sure looks good on there.
Thanks, I was worried about the red not matching, but it is actually really close.
Nice product! Any member here end up buying one off you?
that looks really good on the bike!!!
Not yet, I have one posted on ebay at the moment. If you know anyone interested, here is the link.
https://www.ebay.com/itm/1983-Honda-...7700%7Ciid%3A1
Did you ever try the acetone to help smooth out your prints.
If its on the internet its got to be true they can't put any lie's on the internet
I looked into it and it only works on abs. I am currently using pla. I the future I would like to use abs and acetone.
Can you whip us up some 185s fenders and seat pans? j/k
The headlight looks great.
MrC.
mrc_builds on YouTube Channel
https://www.youtube.com/channel/UCmw...confirmation=1
My Addiction
85 200m "Tallahassee"
84 200x "SouthPort"
84 200x "Van Halen"
84 250r "lucky"
85 250sx "Enterprise"
85 350x "The Money Pit"
85 350x Code Red
86 250r "Unicorn"
86 trx250r
88 Lt250r Suzuki
mrc_builds saves trikes like Jimmy Swaggart saved souls back in the day -said Patriot1