//ArrowChat Code
Results 1 to 3 of 3

Thread: Big Red 250 centrifugal clutch puller ?

  1. #1
    Join Date
    Jun 2011
    Location
    SW Florida
    --
    11

    Big Red 250 centrifugal clutch puller ?

    The kick starter on this 250es slips and I am ready to change the one way in the centrifugal clutch. The manual says a puller is needed for centrifugal hub, is one necessary and what does it look like? Anything special?

    I googled the puller part # 07933-HB3000A . That comes up a threaded puller and the manual says use a two jaw puller?
    Last edited by Otis0; 01-30-2021 at 07:37 PM.

  2. #2
    Join Date
    Jul 2009
    Location
    South Florida
    --
    6,722
    I always try a light tap with a brass first , their only lightly pressed on , if that doesn’t work I use the correct 35mm puller .
    78 atc 90/180cc Dickson Full Suspension
    76 ATC90/180cc Nicholson
    77 atc 90 Dickson Full Suspension
    84 KLT 110/123cc Powroll Racer from 80s
    87 atc 125m stock
    84 atc 200x Curtis Sparks
    84 atc 200x Powroll My race bike from 80's
    83 atc70/108cc Powroll blue Xmas Special
    81 atc185s HP-ATC full suspension

    Performance Shop is Open PM me for Service

    My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10

  3. #3
    Join Date
    Jun 2011
    Location
    SW Florida
    --
    11
    Click image for larger version. 

Name:	42C6267C-E7C9-4375-A1C6-1F2B8657BDE1.jpeg 
Views:	31 
Size:	1.29 MB 
ID:	266507Click image for larger version. 

Name:	5A75F93C-139D-4E96-9331-F80C17CBAC0C.jpeg 
Views:	31 
Size:	1.51 MB 
ID:	266506Click image for larger version. 

Name:	6E18DD86-DE9A-4825-9839-C7A8DBD5BBC9.jpeg 
Views:	30 
Size:	1.10 MB 
ID:	266505Thanks short line, I have the parts and gasket so it went well. The centrifugal came off with a tap . The old one way had flat spots on the rollers, the matching surfaces i.d. and o.d. have some chatter marks I polished a bit with some 400 grit paper. Replaced the seals and buttoned it up the worst part was gasket removal.Click image for larger version. 

Name:	6907D80F-1EE1-49D4-B195-0316CAC1920F.jpeg 
Views:	31 
Size:	1.49 MB 
ID:	266504
    The kickstart works good now, but I notice the lever was well forward when the dots are lined up, the p o had it 4-5 splines rearward for longer kick, will it hurt to have the lever back for better kick stroke? Thanks
    Last edited by Otis0; 02-03-2021 at 07:56 PM.

//ArrowChat Integreation Code //