First Time Rider
Arm chair racerNew to the board
Hi, since I have had my Ytm200, the engine has always had a tick to it. I have adjusted valves and the timing chain, but the noise hasn't gone away. The only thing I've noticed was that one of the teeth on the timing gear is chipped. Could this possibly be the source? Any help would be appreciated. Thanks.
-Mike
Power User
Teaching quads a lesson
I suppose that it could be.
Power User
Lord of the trike
Pull the cam and check the lobs on the rocker arms. They often wear over time and have flat spots on the surface the runs on the cam causing a tick that valve adjustments won’t cure.
Sent from my iPhone using Tapatalk
1984 Yamaha YT 60 Tri Zinger(current project)
1983 Yamaha YTM 200 (rear suspension kit)..... long term project
2004 BMW R1150R
1972 Honda CT 70
2007 Lifan 110
First Time Rider
Arm chair racerNew to the board
Once I have the cam pulled, how do I remove the rocker arms? Thanks.
-Mike
Power User
Catch me if you can
Invest in a manual if you haven’t. The shafts come out with a slideOriginally Posted by Mike33
, or the backyard equivalent of one, and then the rocker arms just fall out of the inspection covers. Mark them as I suspect they are identical and you’ll want to put them back together the same way they were.
Last edited by El Camexican; 12-19-2021 at 02:37 PM.
It sucks to get old
Reply With Quote