I was wondering if anyone knows of a service to repair a bent swing arm for a 86 honda 350 x or a replacement swing arm that dont cost a arm and a leg as this is a build in progress,the end were the internal needle bearings are is were you can see it is slightly twisted,i was thinking i could cut the swing arm 4 inches back on that end and buy a doner with the same bearing diameter cut that back the same 4 inches and re weld,the only thing is there are no diagrams with datum points to go off for refrence,will a 250 r swing arm work on the 86 350 x??! anyone wants to chime in please do so i am open for ideas thank you!