Does anyone make the intake boots from a pv top end that curves so the filter doesn’t hit the pipe. Mine works but is still too close to my liking.
Sent from my iPhone using Tapatalk
Does anyone make the intake boots from a pv top end that curves so the filter doesn’t hit the pipe. Mine works but is still too close to my liking.
Sent from my iPhone using Tapatalk
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
I looked for something aftermarket a year or two back and found nothing. There is a PV thread on here by Neverlift you should checkout if you haven’t. He plumbed his Tri-Z using silicone hose. Came out pretty nice.
It sucks to get old
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
Mine is right against it.
Keep exhaust wrap around it. Been like this for a while hasn’t melted the filter.
Sent from my iPhone using Tapatalk
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
UPP makes an offset for a Blaster 38 mill carb.
250r rules
Will a 85-86 250r intake work.
250r rules
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
I contacted upp to see if they would make any. I highly doubt it though.
Sent from my iPhone using Tapatalk
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
Upp contact me back they might have interest in making some I’ll post if they say yes!
Sent from my iPhone using Tapatalk
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110