Reply With QuoteI always put the parts in the left Case half , mainly because of the inner kick starter assembly / gears .
Not sure if it’s even doable any other way .
New to the board
Arm chair racerNew to the board
Have my bottom end ready to reassemble. Which side do you normally drop the trans, crank, etc. into before putting the halves together?
Sent from my SM-S908U using Tapatalk
Power User
The day begins with 3WW
I always put the parts in the left Case half , mainly because of the inner kick starter assembly / gears .
Not sure if it’s even doable any other way .
78 atc 90/180cc Dickson Full Suspension
76 ATC90/180cc Nicholson
77 atc 90 Dickson Full Suspension
84 KLT 110/123cc Powroll Racer from 80s
87 atc 125m stock
84 atc 200x Curtis Sparks
84 atc 200x Powroll My race bike from 80's
83 atc70/108cc Powroll blue Xmas Special
81 atc185s HP-ATC full suspension
Performance Shop is Open PM me for Service
My Feedback http://www.3wheelerworld.com/showthr...ck+shortline10
New to the board
Arm chair racerNew to the board
That's where I ended up going with it. I don't have a book but was planning on putting the kick assembly in the right case half and everything else in the left.Originally Posted by shortline10
Sent from my SM-S908U using Tapatalk