Registered User
New to the board
Hi,
New to the forum. I am building a TRI-Z from a few basket cases and one of the final pieces I need is the exhaust gasket from the cylinder to the DG expansion chamber. I see the exact spacer/gasket I need in the 3WW Shop here on the site. Problem is I ordered one about 3 weeks ago and sent a follow up message with no answer. Order has been processing since I placed it on July 17th.
Does anyone know if they still make them or anyone who does?
Thank you,
Mike
Just Too Addicted
Arm chair racerJust too addicted
I’m assuming they don’t make it anymore the site hasn’t been updated in forever. I got one of those but it was at least 5 or six years ago.
Sent from my iPhone using Tapatalk
[/SIGPIC]
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
Registered User
New to the board
Damn, I had a feeling the site might be inactive. Thanks for the feedback.Originally Posted by 6spdls1z28
If anyone has one, I am looking to buy one!
Just Too Addicted
Arm chair racerJust too addicted
I could be wrong though hopefully one of the moderators will answer you. I’d post a new thread specifically asking if the site is still active.
Sent from my iPhone using Tapatalk
85 350x
83 200x-sold
×2 85 200x-sold
06 kx250f-sold
86 tecate-sold
86 tri z powervalved
85 BIG red
18 rmz250
87 lt80
19 ttr110
At The Back Of The Pack
Arm chair racerFirst time rider
Welcome to the board Mike! I look forward to more three wheeler stuff on basket case garage in the future. It looks like muthey hasn't been very active here lately, maybe someone who knows him can get in touch with him.
There's some info in this thread that may help:
http://www.3wheelerworld.com/showthr...asket-question
El Camexican, can you help Mike out?
Last edited by floydechoes2000; 08-13-2023 at 07:58 AM.
Registered User
New to the board
How did you figure me out lol �� Yes, this is for the Z I'm building on the channel! Thanks for sharing the thread, that's actually where I found that they offered the gasket here on the 3WW shop. Hoping that someone sees this who maybe can get one of these gaskets to me; I bet you there's one sitting on someones counter somewhere! Until then, I am planning to use stainless shims to fill the gap and a standard exhaust crush washer.
Thanks again Floyd!
Mike
Power User
Catch me if you can
Yep, best bet is to send him a PM. He makes a great product.
It sucks to get old
Reply With Quote