//ArrowChat Code
Page 2 of 2 FirstFirst 1 2
Results 16 to 17 of 17

Thread: KTX plastics

  1. 01-31-2024, 09:54 AM #16
    sjsst41
    sjsst41 is offline New to the board Arm chair racerNew to the board
    Join Date
    Jan 2024
    Location
    Amherst, NH
    --
    39
    I’ll post pics and a more extensive fit review once I get them installed. The Clarke tank came in and I can say the color match between the KTX plastics and tank is very good.
    Reply With Quote Reply With Quote
  2. 04-16-2024, 09:10 PM #17
    sjsst41
    sjsst41 is offline New to the board Arm chair racerNew to the board
    Join Date
    Jan 2024
    Location
    Amherst, NH
    --
    39
    Regarding the KTX plastics, I finally got to the point where I could install the front fender on the ‘85 Tecate, and the predrilled mounting holes were spaced incorrectly, by about one hole diameter inward. An easy correction, but annoying. I do like the design of the front fenders as it is shorter than stock (in the back)which was a mod I planned to make, so that feature makes up for the hole misplacement. I hope to have the rear fenders ready to install in a few weeks and will try to have feedback then.
    Reply With Quote Reply With Quote
//ArrowChat Integreation Code //