Just Too Addicted
Arm chair racerJust too addicted
got a quick question on tightening my chain..
my manual reads like so:
1.Loosen the 4 cap screws on top of the the axle housing
2. Turn the adjuster nut on the rear of the axle housing until the chain has 1.2-1.6" or slack between the chain buffer and rear sprocket; then tighten the 4 cap screws to 72ft/lbs
my question is isnt 72ft/lbs alot for an alum housing??? im going to adjust my chain tomorrow and i dont want to strip the threads or twist off the screws
RIDE IT LIKE YOU STOLE IT! AND NEVER LOOK BACK, THEY ARE TOO FAR BEHIND TO SEE!!
Id rather have a sister in a WHORE HOUSE than a brother in a FORD!
First Time Rider
Arm chair racerNew to the board
the housing is alum but the nuts on the bottom of the housing are on a steel and the nuts are steel also. just dont over do it cause you can strip them out like i did.
Reply With Quote