New to the board
Arm chair racerNew to the board
I've been searching for a bigger carb to put on my 86 250r.
I've heard a lot of people recommend this carb. What do you think?
http://www.eddie-sanders-racing.com/...products_id=26
It has been ported and polished. Currently I've been running a bored out stock carb. I plan on dropping a 4mil stroker crank in her soon.
What's your opinion or recommendations?
1986 ATC 250R
It's running now!!
Just Too Addicted
Arm chair racerJust too addicted
i hear nothing but good things about PWK's
Always finding new and exciting ways to not give a hoot in hell
Catch me if you can
39mm PWK all the way.
New to the board
Arm chair racerNew to the board
Thanks for the input. I didn't want to go to big and suffer to much on the bottom. I was worried a 38 might be to big. I guess we'll find out.
1986 ATC 250R
It's running now!!
First Time Rider
Arm chair racerNew to the board
I've heard that a 38pwk off of a 00' cr250 with a 1368 needle from a 98' cr250 works great with the way that it is jetted. Anyone running that seup?
New to the board
Arm chair racerNew to the board
I have a esr tmxx 41.5 mm carb that I will make some one a great deal on. but back to the topic I agree with billy 39mm unless you are a mx/woods rider than I would probably go with the 38 for a little better bottom , but if your looking for bottom end buy a 4 stroke!!!!!!
New to the board
Arm chair racerNew to the board
No it's a straight dune bike. Sounds like 39 it is then. No four strokes for me.
1986 ATC 250R
It's running now!!
Reply With Quote