Electric start for 84'honda 200s atc...

[vanzant]

I've found an electric starter for a 84'honda 200s atc,through a company called GOKI. Has any of you converted a 84'honda 200s atc from pull start to electric start?
if so plz let me know how it went.Does it have push button start?
GOKI sales it for around $250.00...i think it'd be worth it.

[bigredhead]

they make them for the 350x and possibly others.. i've heard of them before..

Does it come with a case cover ? to allow the gears from the starter etc... to mount up ?

[mx600]

another option might be pulling the parts you need from a 200e or 200m, both had electric start and chain drive so the cases should match up.

The Goki kit looks pretty straight forward. If you haven't seen this yet, here's a pic:
http://www.spinreel.com/185-200s.jpg

[Huffa]

Vanzant

You don't want one of those, thats nuts (are you wacked out ) to pay that much! I'll sell you this whole motor & starter for 170. The hi-low sub trans you don't need, right? 600 wants that (sub trans), front & rear rack & hitch set up.

You could just slap the whole motor in and if it's real healthy then just sell your other one or have it as a back up or whatever!


Starter does work, engine does run but I only ran it for a few seconds so before I sell it I'm going to test the compression and make sure it's healthy.

This engine will clean up real nice with little work and I'll do that before I sell it.

I prefer to sell engine & starter as a package and really don't want to split them up.

Need any other parts? I know 600 would like the sub trans & hitch set up


I might have another identiacl machine,same shape as this one, in a few days.

[mx600]

Vanzant

I'll sell you this whole motor & starter for 170. The hi-low sub trans you don't need, right? 600 wants that (sub trans), front & rear rack & hitch set up.




Need any other parts?


I might have another identiacl machine,same shape as this one, in a few days.

Hey, you're supposed to keep the classifieds in the classifieds section!

Actually I was more interested in the E-start than the sub trans, but I've got other priorities right now.

I think you'd have to make a clearance dent in a 200s downtube to accept the 200e or 200m starter. Should be relatively easy with a BFH.