Activity Stream

No the gaskets are different- not just a flat rubber ring its molded alot different. shep I was planning on doing a batch of them but wont be...

Can anyone confirm the 17631-VM5-300 gasket (for the 87 TRX200) will fit/work on the 86 350X fuel filler cap? The gasket is not listed separately for...

Just to tie this off, today I left a message for Tammy. My seat pan is okay but has a busted stud (maybe two). I found another pan donor on eBay...

These wheels are junk but they’ll make decent rider grade wheels when I’m done. Still have my eyes open for nicer rears in the meantime. Any...

Clutch is working.

Slowly but surely.

Getting there…

You are going through a lot of work with this trike. My advice is to do your homework, and know what you're getting yourself into, with the front end...

You would dig up a post from 2013 and comment on it now ........why do people from India all sound like Gandi ?

Small update. I found someone locally that can laser cut 25mm billet alloy to an AutoCAD drawing. Been doing some basic measurement off my roadgoing...

Wrong! Anyone else doing this, make sure to pay attention when disassembling. The flat nylon washer goes on the switch first, followed by the wave...

Yep, I saw it this morning. Reminds me of the ol’ saying ‘can lead a horse to water but can’t make em drink’. Or your ride will die of thirst…….

Funny....I put the part# in a ebay search and they are there. Maybe look again? shep

Yeah shortline I have. Nothing. Tried everyplace I could find. Lots of places list it but when you go there it is no longer available. Thanks for the...

Did you try eBay with the part number ?

A bit more tweaking and some cleaning:

LOL, I would be a rich man if I had all the parts bikes I had back then. I was picking up 350X parts bikes about every month for $300 range. I also...

Tool box still looks good. On to the wheels:

I have the 330 kit on my R. The power increase was a bunch. But there is 2 down falls. It runs really hot now even with oversize rads, and its too...

I may have found something to rejuvenate the tool box. We’ll see how it looks in the morning.

If you cant find a leak, check the jet in the middle of the carb, the one with all the little sideways holes in it. If one of those holes is the...

If you're sure the carburetor is clean, I would suspect an air leak somewhere. If the WD-40 doesn't yield any results, a leak-down test may be in...

Yeah ill try that with the WD-40 but nothing obvious with a visual inspection

If nothing obvious is found via a visual inspection, you can try spraying WD-40 around the area while the bike is running. The idle will increase, if...

Quick question: The O-Rings called out in the parts fiche… we have cross section and either ID or OD. Do we know which it is? For example: 54 X...

Muffler is here! I was going to blast and paint it, but I think I’ll skip the blast. This thing is NICE!

How would i check that? just run it and spray with soapy water?