Activity Stream

One of mine is cracked too. Well, mine are stacked nuts but the ones I just got one of those is cracked.

Thanks again J!m :cool: Looks like I need a decompression cable… oye. Where do go for that? Also made some new motor mount bushings to...

Stayin warm and dry, now.

Good idea and nice inexpensive fix.

So as a last ditch effort I took a chance and ordered a choke plunger for Keihin PWK series, these can be had on ebay for around $10. You will only...

For bikes that aren't garage kept to keep the corrosion/rust off the links and the O-rings soft I use ATF (auto transmission fluid) just pour some on...

never lubed a chain in 30 years period, we run sand good chain no lube

That's not the issue. With the airbox lid on it will not run correctly. It runs pretty good without the lid. But you are right if I end up not...

The filter looks fine. It just needs rejeted to run with out the air box lid it’s getting to much air for the stock jetting

i have an update on this. The big red would not run perfectly with the airbox lid on. I believe this filter setup is so much larger than the...

I finally got around to installing this filter. It does fit but requires trimming off the rear filter mount inside of the air box. I hated to...

Did get pretty lucky I’m going to do some more work to this yz top end and make it even faster!

All good. I typically run wiseco too but the pro x at the time was a smokin deal. It lasted a good 3 years and had a lot of hours on it. Think I’m...

It might be worth saving potential aggravation as other failures are discovered… the seller may offer a “core” charge for your old one too.

Thanks! :cool: I attempted to clean the front brake caliper and ended up ruining the pin seals. They have been saturated in for oil for decades...

Looks good. Nice & tidy little workspace too!

Making way on the mighty 350X! Where is a good place to get a fuel petcock? Mine is a cheap Amazon one and it’s leaking.. haha.

I think you will need to get your hands on a dash before you can 3 D print one that will actually fit. There are so many shapes involved with this...

I am planning to use an inline filter. There was only 1 oring with this petcock but I trimmed down the screen so that the plastic base is seated...

Double post…

That is certainly sub-optimal. Lucky the bore was not destroyed too, or a lock up and break the rod. Could have been much worse!

That's not good! Sorry to hear that. I had one let go like that in my R, many, many years ago. I can't remember what brand of piston though. After...

Agree with the inline filter, I have them on all my bikes for extra peace of mind

Footy, did it come with 2 sealing washers? A round o-ring washer is used without the filter and the flat washer is used with the filter. Oem...

im seeing 200x for under 2000 more like 1500. rarely see liquid rs for sale. I think i sold both my 85s a couple years back for 4500 each, same with...