Activity Stream

You are correct.

All, I picked up a front wheel and tyre off an '85 250R on the weekend. Just want to check, which side the hub face goes, I assume its the side with...

I’ve done that, also. Remember, that process strips the coating off, as well. I always keep mine inside where it won’t ever condensate. 10 years...

Great, thanks. I actually filled the tank with vinegar for several days to eat out all the rust and it did a great job. Looked as good as new...

Take the seal back off. Put the cap in apple cider vinegar for a couple days. Blow it out with an air compressor real good(in a rag). There are two...

https://mail.google.com/mail/u/0?ui=2&ik=2bd076d320&attid=0.1&permmsgid=msg-a:r-970505494787787363&th=19678e616ec73743&view=att&disp=safe&realattid=19...

What about the kicker mech? Is it something there that's throwing the specified adjustment off? Have you removed the cable and checked it doesn't...

Saturday may 24th drag racing, I will be there Sunday the 25th tt races,won't be there Fairchild,WI Search on FB quad county atv club for info

Do you have another way that you’d prefer me contact you? If not, I’ll just shoot you a message on here when I get the part and am ready to send it...

Yes I can do it. Its a process but its a sweet one. Will look like this when done. I use to offer the service on ebay and got to much biz. It...

Thanks for the input. I went ahead and ordered another assembly, and it’s supposed to be here in the next few days. If you’d be willing to do it, I’d...

Very nice , love it

So glad we have it. She’s a lot of fun.

Hope you enjoy this booklet.

You can see here it was purchased with separate prices on each item but also says no charge.

This is what was in the duct tape below the gas tank. Should explain why the left case was cut to expose the front sprocket This ‘trail seat’ was...

Here is more of this ‘cat’. Got the unicorn seat in a box. These pics were the day we pulled it out. It cleaned up real nice and started...

^way over loaded;)

Well, 4 years later…I couldn’t let a good frame go down for the count.

Walk around. Still trying to dial it in.https://youtube.com/shorts/vNcMktGJVpg?si=Zj71DxrB_zf6DTSU

Yes Tim but tell him the real issue...the teeth are not matching up and worn. I back cut them measure and shim them. New spring and bingo no slipping...

Ok thanks for the help found out I have a 86 motor on 85 frame I been ordering wrong parts.

I went with a Mikuni TMR-28 carb, it’s been modified by Yoshimura and has some custom guts that Yoshimura designed. The frame hoop had to be cut and...